Allied Telesis AT-S94 - Manual (Page 130)

Configuring System Logs
Page 130
The Event Log Page contains the following fields:
The Configure Log Outputs table displays the following log information:
• Type — Indicates the log type included in the output. The possible values are:
– Console — Indicates that the output is of a console log.
– Temporary — Indicates that the output is of the temporary memory log.
– Syslog — Indicates that the output is of a system log.
– Flash — Indicates that the output is of a Flash memory log.
• IP Address — Displays the defined IP address of the syslog server.
• Minimum Severity — Indicates the defined minimum severity level.
• Description — Provides additional information about the syslog server.
Clearing Event Logs
To clear all events from the log:
1. Click System > Event Log. The Event Log Page opens:
2. Click Clear Logs. The stored logs are cleared. If logging is enabled, the system begins to log new events.
Adding Log Servers
To add a log server:
1. Click System > Event Log. The Event Log Page opens.
2. Select a Log Type in the Configure Log Outputs table.
3. Click Add. The Add Syslog Page opens:
Figure 86: Add Syslog Page