Allied Telesis x610 Series Layer 3 - Manual (Page 75)

x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
75
Unpacking a Switch
To unpack a switch, perform the following procedure:
1. Remove all components from the shipping packages.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Place the switch on a level, secure surface.
3. For a non-PoE switch, make sure the following components are
included in your switch package. If any item is missing or damaged,
contact your Allied Telesis sales representative for assistance.
ˆ
One non-PoE x610 Series Layer 3 Gigabit Ethernet Switch
ˆ
Two rack-mount brackets
ˆ
Twelve flathead Phillips rack-mount bracket screws
ˆ
Four regional AC power cords (Americas, Australia, EU, Japan,
and UK only)
ˆ
One AC power cord retaining clip
ˆ
One management cable for local management
4. For a PoE switch, make sure the following components are included in
your switch package. If any item is missing or damaged, contact your
Allied Telesis sales representative for assistance.
ˆ
One PoE x610 Series Layer 3 Gigabit Ethernet Switch
ˆ
Two rack-mount brackets
ˆ
Twelve flathead Phillips rack-mount bracket screws
ˆ
One management cable for local management