Figure 135: tightening the handle locking screw – Allied Telesis AT-SBx31CFC960 User Manual
Page 195
SwitchBlade x3112 Chassis Switch and AT-SBx31CFC960 Card Installation Guide
195
Figure 135. Tightening the Handle Locking Screw
10. Before attaching the power wires from the power supply to the circuit
breaker in the wiring closet, check that the circuit breaker is off.
11. Connect the power wires to the circuit breaker.
12. Turn the circuit breaker on.
13. Turn the On/Off switch on the power supply to the On position. See
14. Do one of the following:
If the chassis has two AT-SBxPWRSYS1 DC Power Supplies,
repeat this procedure to power on the second power supply.
Otherwise, go to “Monitoring the Initialization Process” on
page 206.
Handle locking
screw
This manual is related to the following products: