Allied Telesis AT-SBx31CFC960 - Manual (Page 178)

Chapter 9: Powering On the Chassis
178
Powering on the AT-SBxPWRPOE1 AC Power Supply
This section contains instructions on how to power on the AT-
SBxPWRPOE1 AC Power Supply. For installation instructions, refer to
“Installing the AT-SBxPWRPOE1 AC Power Supply” on page 113. To
power on the power supply, perform the following procedure:
1. Identify AC sockets A and B in the recessed panel on the back panel
of the chassis, shown in Figure 111 on page 175. The sockets are for
the AT-SBxPWRPOE1 Power Supplies in slots A and B on the front
panel of the chassis.
2. Plug the AC power cord that comes with the power supply into a plug
whose corresponding slot on the front panel has a PoE power supply.
If the chassis has two AT-SBxPWRPOE1 Power Supplies, you may
power on either supply first. The illustration in Figure 114 shows the
AC power cord being connected to connector A for the power supply in
slot A on the front panel.
Figure 114. Connecting the AC Power Cord for the AT-SBxPWRPOE1
Power Supply