Figure 22: remote address list – Allied Telesis AT-TQ Series User Manual
Page 78
Chapter 3: Manage Menu
78
Note
You cannot configure the fields of a WDS bridge if the
corresponding radio is disabled. If the fields are deactivated, refer to
“Configuring Basic Radio Settings” on page 43 or “Configuring the
Radio Settings” on page 46 for instructions on how to enable the
radio.
The Local Address field displays the MAC address of the radio. You
cannot change this field.
3. Click the dialog circle with the arrow to the right of the Remote Address
field.
The device displays the neighboring access points in a window. An
example is shown in Figure 22.
Figure 22. Remote Address List
4. Click the MAC address of the remote access point of the WDS bridge.
You may select only one neighboring access point.
5. Click the Encryption pull-down menu and select the encryption method
for the WDS bridge. The available selections depend on the radio
mode and VAP0 security level. Refer to Table 8 on page 74 for the
available security levels. If you do not want the bridge to use
encryption, select None, the default setting.
6. Configure the settings of the encryption method.
The encryption parameters are described in the following sections: