Allied Telesis AT-TQ Series - Manual (Page 42)

Chapter 3: Manage Menu
42
Note
If the Country pull-down menu is deactivated, the country parameter
was set by the manufacturer and cannot be changed. Contact your
Allied Telesis sales representative for assistance if the setting is not
correct for your country or region.
The access point displays a confirmation prompt.
3. Click OK to change the country setting or Cancel to cancel the
procedure.
If you click OK, the access point changes the country setting and
disables both radios on the access point. For instructions on how to
enable the radios and configure their settings, refer to “Configuring
Basic Radio Settings” on page 43 and “Configuring the Radio Settings”
on page 46.
This procedure does not require clicking the Update button.
You must now reboot the access point. The new country setting is not
active until the unit is rebooted. To reboot the unit, either power off and
on the unit or continue with these steps:
4. From the Maintenance menu, select Configuration.
5. Click the Reboot button in the To Reboot the Access Point section of
the “Manage the Access Point’s Configuration” window.
6. When the access point displays a confirmation prompt, click OK to
reboot the unit or Cancel to cancel the procedure.
7. To resume managing the unit, wait for it to complete initializing its
management software and then start a new management session.