Allied Telesis AT-TQ Series - Manual (Page 157)

AT-TQ Wireless Access Point Series User’s Guide
157
Manually Setting the Date and Time
If the access point does not have access to an SNTP server, you may set
the date and time manually. The unit adds the date and time to log
messages and SNMP traps.
Note
If you configure the date and time manually, you have to reconfigure
them whenever the access point is reset or powered off.
To manually set the date and time, perform the following procedure:
1. From the Services menu, select NTP.
The access point displays the “Modify How the Access Point Discovers
the Time” window.
2. Click the Manually dialog circle for the Set System Time parameter.
Refer to Figure 51. This is the default setting.
Figure 51. Modify How the Access Point Discovers the Time Window -
Manually Setting the Date and Time
3. Use the pull-down menus in System Date to set the current month,
day, and year.
4. Use the pull-down menus in System Time to set the current hours and
minutes. The hours are in 24 hours. For example, 14 represent 2:00
p.m.
5. Use the pull-down menu in Time Zone to set the time zone of the
location of the access point.