Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 79)

79
End of AGS SETUP
menu
UP TOP AGS
ADV/MATE/AGS/SETUP-----
cool down time 0
minutes
DOWN UP INC DEC
ADV/MATE/AGS/SETUP-----
warm up time 0
minutes
DOWN UP INC DEC
After the FX charging has been disabled, the cool
down time screen allows the user to adjust the
number of minutes the generator will cool down
before being shut off. This time should follow
the manufacturer’s recommendations. Press the
key to view the warm up time screen
The warm up time screen allow the user to
adjust the number of minutes the generator
will warm up before the FX charging begins.
This time should follow the manufacturer’s
recommendations. Press the key to
view the End of AGS SETUP time screen
NOTE: Cool down and warm up times are not
used when DC generator (dc genset) is selected.
In the End of the AGS SETUP screen Press
the
programming.
NOTE: Cool down and warm up times are not
used when DC generator (dc genset) is selected.