Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 52)

52
HOT KEYS
—turns off all the FX inverters connected
to the MATE
—the inverter begins search mode if the
AC load connected is smaller than allowed by the
programming of the search function.
—turns on all the FX inverters connected
to the MATE.
—returns to the point in the menu system
where you entered the INVERTER CONTROL
screen.
PRESS ONCE: INV
INVERTER CONTROL
Currently: ON
OFF SRCH ON OK
The INV “hot” key takes you to the INVERTER CONTROL screen allowing direct control of
the FX’s inverter from anywhere in the menu system.
The green LED indicator above the INV has three modes:
• Flashing—the inverter is either in the search or power save modes
• Continuously On—DC battery power is converted to AC power and the FX is supplying
loads or selling to the grid
• Off—the inverter is not converting DC power to AC power or when the AC input source is
powering the loads
INV
Hot Key
MAIN-------------------------
1:35:04p
SUM STATUS SETUP ADV
INV Hot Key