Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 77)

77
AGS Enabled
This is the overall control for the AGS Mode. If
AGS is not enabled, none of the AGS settings
or controls will work. Enable the AGS first by
pressing the <YES? soft key and then establish
your settings.
After enabling the AGS Mode, press the
soft key to continue to the AGS
Control menu.
This screen allows the AGS Mode to be changed.
Pressing brings up a screen that
allows the user to switch choose from three AGS
control modes sown below.
This screen offers three options for AGS control:
• OFF manually de-energizes the FX AUX
or FLEXnet DC relay output and stops the
generator regardless of any AGS setting; this is
displayed as MAN – OFF.
• AUTO allows AGS settings to start and stop
the generator automatically and is displayed
as either AUTO – ON (when the AUX is
activated), or AUTO – OFF (when the AUX is
deactivated).
• ON will manually energize the FX AUX output
and start the generator regardless of any AGS
setting; this is displayed as MAN – ON.
• OFF and ON are considered “manual”
selections, hence the MAN-OFF and MAN-ON
screen displays.
Press the soft key to view the next
setup screen.
ADV/MATE/AGS/SETUP------------
AGS enabled: NO
DOWN UP NO YES
ADV/MATE/AGS/SETUP-------------
AGS enabled: YES
DOWN UP NO YES
ADV/MATE/AGS/SETUP-------------
AGS control: MAN-OFF
DOWN UP CHANGE
GEN START CONTROL
currently: MAN-OFF
OFF AUTO ON OK
AGS Control
ADV/MATE/AGS/SETUP-------------
AGS control: MAN-OFF
DOWN UP CHANGE