Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 110)

110
STATUS/FX/METER---P00
charger 0.0 aac
current
DOWN UP TOP PORT
STATUS/FX/METER---P00
input 0.0 aac
current
DOWN UP TOP PORT
STATUS/FX/METER---P00
sell 0.0 aac
current
DOWN UP TOP PORT
STATUS/FX/METER---P00
FX firmware revision
DOWN UP TOP PORT
STATUS/FX/METER---------
end of meter menu
UP TOP STATUS
FX BATTERY SCREENS
STATUS/FX/METER----P00
inverter 0.0 aac
current
DOWN UP TOP PORT
STATUS/FX/BATT-----P00
battery 25.0 vdc
temp compensated
DOWN UP TOP PORT
STATUS/FX/BATT-----P00
absorb 28.8 vdc
setpoint
DOWN UP TOP PORT
STATUS/FX/BATT-----P00
absorb 01.5 hrs
time remaining
DOWN UP TOP PORT
STATUS/FX/BATT-----P00
float 26.8 vdc
setpoint
DOWN UP TOP PORT
STATUS/FX/BATT------P00
float 00.8 hrs
time remaining
DOWN UP TOP PORT
STATUS/FX/BATT-------P00
refloat 25.0 vdc
setpoint
DOWN UP TOP PORT
STATUS/FX/BATT-------P00
equalize 28.8 vdc
setpoint
DOWN UP TOP POR T
STATUS/FX/BATT-----------
end of battery menu
UP TOP STATUS
FX ERRORS
STATUS/FX/PAGE1-----
choose category:
MODES METER BATT PG2
STATUS/FX/PAGE2---------
choose category:
PG1 ERROR WARN PG3
STATUS/FX/ERROR—-P00
low ac output No
voltage
DOWN STATUS PORT
STATUS/FX/ERROR—-P00
inverter No
overtemp
DOWN UP TOP PORT
STATUS/FX/ERROR—-P00
low battery No
voltage
DOWN UP TOP PORT
STATUS/FX/ERROR--P00
phase loss No
error
DOWN UP TOP PORT
STATUS/FX/ERROR--P00
high battery No
voltage
DOWN UP TOP PORT
STATUS/FX/ERROR—-P00
ac output No
shorted
DOWN UP TOP PORT
STATUS/FX/ERROR—-P00
ac output No
backfeed
DOWN UP TOP PORT
STATUS/FX/ERROR—-P00
stacking No
error detected
DOWN UP TOP PORT
STATUS/FX/ERROR---------
end of error menu
UP TOP STATUS
STATUS/FX/BATT-----P00
battery 25.0 vdc
actual
DOWN STATUS PORT
STATUS/FX/PAGE1---------
choose category:
MODES METER BATT PG2
STATUS/FX/BATT-----P00
batt temp. 255
(not in degree C/F)
DOWN UP TOP STATUS
STATUS/FX/BATT-----P00
equalize 02.0 hrs
time remaining
DOWN UP TOP PORT
STATUS/FX/PAGE2-----
choose category:
PG1 ERROR WARN PG3
STATUS/FX/WARN---P00
acin freq NO
too high
DOWN STATUS PORT
STATUS/FX/WARN---P00
acin freq NO
too low
DOWN UP TOP PORT
FX WARNINGS
STATUS/FX/WARN---P00
acin voltage NO
too high
DOWN UP TOP PORT