Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 35)

35
Press the soft key after a device is
added to, moved, or removed from the HUB.
The MATE has found the HUB and will
automatically go to the Port Assignment screen.
After displaying the devices connected to each
Port, the MATE returns to the choose category
screen on its own.
SETUP/MATE/COMM--------------
choose category:
BACK REPOLL PC DEBUG
Searching for Devices
HUB Found
Port Assignment
1> FX 2> FX 3> CC 4> CC
5> 6> 7> 8>
9> 10> 2M>
NOTE: Disconnecting the MATE’s CAT5 cable and then reconnecting it also performs the
re-poll task, but the cable can be inconvenient to remove from a mounted MATE.
SETUP/MATE/COMM/PC----------
PC communications: OFF
BACK OFF ON
SETUP/MATE/COMM--------------
choose category:
BACK REPOLL PC DEBUG
The next communication function deals with the
MATE/personal computer interface. Press the
soft key to enable or disable the MATE’s
RS232 communications port.
In the PC communications screen, choose ON
or OFF by pressing the respective soft key. Press
the soft key to return to the choose
category screen.