Outback Power Systems MATE2 System Controller and Display Installation and User Manual User Manual
Page 108
108
ADV/SETTINGS/WARNING
changes made could
adversely effect
system performance
Before entering the
ADVANCED screens, a
warning message appears.
Any changes can always
be undone, different values
entered, or the MATE can
be returned to its factory
default settings.
After pressing the
the password number
141 appears, the ad-
vanced screens for the
FX. Charge Controller,
and MATE become
available.
The advanced FX screens include:
u
FX search sensitivity, pulse length,
and pulse spacing
u
low battery cut-off and cut-in set
points
u
adjustments to the output voltage
u
charger limits
u
absorb, float, refloat, and equalize
settings
u
resetting the FX to factory defaults
u
AC grid usage and limits
u
generator usage and limts
u
AUX functions, including genalert,
loadshed, vent fan, and diversion
functions
u
FX stacking
u
selling voltage and grid tie settings
u
VAC and VDC calibrations
ADV/PASSWORD
enter the password
132
ENTER INC DEC EXIT
ADV-------------------------------------
choose product
FX C C DC MATE
The advanced CC screens include:
u
AUX output function
u
AUX output control
u
programming of both the
FLEXmax60 and FLEXmax 80
Charge Controllers
The advanced MATE screens include:
u
HBX grid use and drop setpoints
and delays, AC input control
u
GRIDUSE weekday and weekend
start and stop times
u
AGS or advanced generator start
functions such as SETUP, QUIET
TIME, VOLT START, LOAD START,
MUST RUN, %SOC, TIMERS, AND
EXERCISE
u
resetting the MATE2M to factory
default values
The ADV(anced) menu allows a user
to more precisely adjust the inverter
and charger functions as well as the
generator function and grid-tie set-
points. The ADV menu is password-
protected requiring the password
141 be entered before accesssing the
screens.
The advanced FLEXnet DC screens include:
u
battery bank capacity
u
enable or disable shunts
u
establish the end of charge amps, end of
charge voltage, and amount of time the charge
parameters must be met
u
AUX functions
u
resetting to factory default and clearing the
data log