HP OneView for VMware vCenter - Manual (Page 62)

If there is not enough space available in the selected storage pool, a message is displayed
in the Warnings box.
•
RAID Level: Select a RAID level for the new datastores. The wizard lists all RAID levels
supported by the selected storage pool.
4. Click Next.
The Add Datastores – Specify New Names window opens. See Figure 32 (page 62) .
Figure 32 Add Datastores – Specify New Names window
5. Enter the following information:
•
New Datastore Names: Enter the base name for the new datastores. The # symbol is
required and represents the numeric sequence for the new datastore names. In the
generated datastore names, the # symbol is replaced with a number.
•
Where # is numeric and starts at: Enter the start value for the numeric sequence of datastore
names. The default values are as follows:
Default start value for numeric sequence Number of datastores to add
1 1–9
01 10–99
001 100–999
The Generated Names box shows the names of the datastores that will be created.
6. Click Next.
The Create Datastores – Review and Validate window opens. See Figure 33 (page 63) .
62 Provisioning storage