beautypg.com

Viewing replications – HP OneView for VMware vCenter User Manual

Page 55

background image

Preferred Path

P4000—Not applicable

3PAR—Not applicable

P6000 EVA—Specifies whether the path uses a port on the controller that is configured
as the preferred path for the vdisk (Yes, No, No preference)

P2000/MSA2000—Not applicable

P9000/XP—Not applicable

Active Path—Specifies whether the path is active or in standby status

If a path is active and then goes offline, a standby path takes over.

Path ID—Path ID assigned by VMware

VMware Disk Identifier—Disk name assigned by VMware

Viewing replications

The Replications tab is displayed in the HP Insight Management tab for selected hosts, clusters,
VMs, and datastores. See

“Replications tab” (page 55)

).

Figure 28 Replications tab

This tab displays the following information:

Source Disk Name—Source replication disk

Source Array—Array identifier for the local (source) array; displayed only for Continuous
Access replications and not supported for P2000/MSA2000 arrays

Replication Type—The type of replication used:

P4000—Snapshot, Remote Snapshot

3PAR—Virtual copy, Physical copy

P6000 EVA—Snapshot, Snapclone, Mirrorclone, Continuous Access

P2000/MSA2000—Not applicable

P9000/XP—P9000 or XP Business Copy, P9000 or XP Snapshot, P9000 or XP Continuous
Access

Replica Name—Target replication disk

Replica Array—Array identifier for the remote (target) array; displayed only for Continuous
Access replications and not supported for P2000/MSA2000 arrays

Replica Status—Status of the replica (for example, PAIR, SUSPEND, or COPY)

Using the Storage Module for vCenter

55