HP ESL E-series Tape Libraries - Manual (Page 98)

Checking the new installation site
Check the new installation site for the library using the guidelines found in the HP StorageWorks ESL
E-Series Pre-Installation Site Survey Instructions. Make sure the new location meets all applicable
clearance, environmental, and power requirements.
Preparing the library for relocation
To prepare the library for relocation, refer to:
• Removing tape cartridges
• Installing shipping restraints and packing
• Disconnecting library cables
CAUTION:
Always prepare the library for relocation before any move.
Removing tape cartridges
To remove tape cartridges:
1. Unload all tape cartridges from the tape drives using your application software.
2. Press Stop on the OCP to stop all library operation.
This places the library off-line after the completion of any currently executing operations.
3. Power the library off.
4. Unlock and open both front doors.
5. Remove all tape cartridges from the library bins.
6. Carefully pack all tapes for shipment.
Installing shipping restraints and packing
To install internal shipping restraints:
Relocating the library 98