HP ESL E-series Tape Libraries - Manual (Page 129)

Message name / description ASCQ ASC Sense
key
CONFIGURATION SETTINGS CORRUPTED
Reconfigure the library. Run the Calibrate Cabinet Test from the OCP. 0A 80 4
LOW POWER ERROR
Check power connections and power supplies. 0F 80 4
PICKER HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
81 4
ROTARY HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
82 4
EXTENSION HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
83 4
VERTICAL HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
84 4
HORIZONTAL HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
85 4
DEPTH HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
See
Table
22
87 4
WARNING SAFE TEMPERATURE EXCEEDED
This is a warning that the temperature in the library exceeds the normal
operational temperature 40
o
C (104
o
F).
00 88 4
MAXIMUM TEMPERATURE EXCEEDED
The robot in the overheated cabinet turns off and remains off until the
temperature returns to an acceptable level. For LTO, the acceptable level
is 52
o
C (127
o
F); for SDLT, the acceptable level is 49
o
C (120
o
F).
• Check whether the air filters need to be replaced.
• Check for fan failure.
• Lower the ambient temperature.
01 88 4
VISION HARDWARE FAILURE
Vision internal failure. 00–FF 89 4
CALIBRATION FAILURE
Check slots, cartridges, targets, and all internal elements. Verify that the
panels are properly seated and that doors are closed. 02 8A 4
HP StorageWorks ESL E-Series Tape Library 129