HP ESL E-series Tape Libraries - Manual (Page 135)

Message name / description ASCQ ASC Sense
key
OVERLAPPED COMMANDS ATTEMPTED
Due to a second command being sent from the same host before a
previous command has completed, the previous command has been
aborted. This may also occur when executing off-line commands via the
control panel and DIAG port simultaneously.
• Verify that the host software application is supported, has up-to-date
patches, and is correctly configured.
• Verify that the library and its components have the current firmware.
00 4E 5
UNCALIBRATED POSITION
System requires calibration. Run the Calibrate Cabinet test from the OCP. 02 8A 5
CLM INVALID START CONDITION
CLM hardware condition is unknown. Run the Robotics to Home Position
test. E0 8B 5
CLM INVALID COMMAND
CLM hardware commanded to position out of system mechanical limits.
• Run the Robotics to Home Position test.
• If the problem persists, calibrate the library.
F0 8B 5
IMPORT OR EXPORT ELEMENT ACCESSED
Load port door has been closed. 01 2B 6
POWER-ON, RESET OR BUS DEVICE RESET OCCURRED
Informational message. The host user should assume the inventory may
have changed, and should ask the library for that information again. 00 29 6
POWER-ON RESET OCCURRED.
Informational message. The host user should assume the inventory may
have changed, and should ask the library for that information again. 01 29 6
BUS RESET OCCURRED.
Informational message. The host user should assume the inventory may
have changed, and should ask the library for that information again. 02 29 6
BUS DEVICE RESET OCCURRED
Informational message. The host user should assume the inventory may
have changed, and should ask the library for that information again. 03 29 6
INTERNAL DEVICE RESET OCCURRED
Informational message. The host user should assume the inventory may
have changed, and should ask the library for that information again. 04 29 6
DOOR WAS OPENED INVENTORY MAY HAVE BEEN CORRUPTED
Close door and retry command after inventory is complete. 00 80 6
SYSTEM STOP BUTTON WAS PRESSED
The STOP button on the control panel was pressed. Press the STOP button
again to start the cabinet. Retry command. 07 80 6
HP StorageWorks ESL E-Series Tape Library 135