HP ESL E-series Tape Libraries - Manual (Page 164)

Information event Event ID
Network configuration set via setup shell 0x601
Web admin account changed 0x602
Web admin account created 0x603
Updated date and time 0x604
Firmware upgrade completed 0x605
Date and time zone have been changed 0x606
Firmware upgrade started 0x607
Firmware upgrade of slave cabinet $framename completed 0x608
FC Bridge Firmware upgrade, $ip, completed 0x609
Drive Cluster FPGA upgrade started. 0x60a
Drive Cluster FPGA upgrade completed to version $version. $clustermsg 0x60b
Firmware upgrade of $type robot with IP address $ip started. 0x60c
Firmware upgrade of $type robot started. 0x60d
Firmware upgrade of $type robot with IP address $ip completed success-
fully.
0x60e
Firmware upgrade of $type robot completed successfully. 0x60f
Date and Time restarted. 0x610
Date and Time sync. 0x611
Library power is turned $librarypower. IP address $ipaddress. 0x612
The network settings for cabinet $framename were updated. 0x901
There is no IP/IPv6 forwarding for cabinet $framename. 0x902
IPv6 forwarding is enabled on cabinet $framename. 0x903
IP forwarding is enabled on cabinet $framename. 0x904
IP and IPv6 forwarding are enabled on cabinet $framename. 0x905
$panelname $name sensor status update, status $status 0xa00
CLM $name sensor status update, status $status 0xa02
The cabinet controller process was shut down 0xa03
Diagnostic command $cmd completed successfully for CLM 0xa04
Diagnostic command $cmd command failed for CLM 0xa05
Cabinet $framename state is $onlinestate with no user intervention needed 0xa06
Event reporting 164