HP ESL E-series Tape Libraries - Manual (Page 79)

Description Green LED Red LED
No CompactFlash disk or valid boot sector image
found. Be sure to transfer the memory module from
the old card to the new card if the Interface Manager
was replaced. Off Blinks 2x per 5
second interval
Specified firmware image files were not found. Neither
the current nor the previous image was found. Off Blinks 3x per 5
second interval
Load or execute command failed (boot code remains
at end of process). This indicates that load, decom-
press, or execution failed on both the current and
previous image files. Off Blinks 4x per 5
second interval
Normal state. Load or execute command succeeded.
Boot code successfully loaded, decompressed, and
initiated execution of one of the image files.
NOTE:
If the library does not proceed beyond this point
after two minutes, the network connection between
the IM and the library is missing. Establish a serial
connection to the IM and enter set net config
esl
to force the IM into discovery. Later,
troubleshoot and repair the network connection
issue.
Blinks 1x per 5
second interval Off
Normal state. Application software is initializing. Blinks 2x per 5
second interval Off
Normal state. Application is identifying all library
components.
NOTE:
The LEDs may be in this state even if a device is
missing.
Blinks 3x per 5
second interval Off
Normal state. Application has identified all library
components. On Off
Network link activity/speed LEDs
Table 13 describes network link activity and speed as indicated by the LEDs for the Interface Manager.
Table 13 Network link activity/speed LEDs
Description Status LED
Port disconnected / no link
Port connected to another Ethernet device
Data is being transmitted / received Off
On
Flashing Link Activity LED (left
side of each Ethernet
port)
Port is operating at 100 Mbps
Port is operating at 10 Mbps, or is not connected (see
Link Activity LED) On
Off Link Speed LED (right
side of each Ethernet
port)
HP StorageWorks ESL E-Series Tape Library 79