HP ESL E-series Tape Libraries - Manual (Page 154)

Warning events Event ID
Robotic Controller not communicating on cabinet $fname. OCP unable
to communicate with cabinet controller.
0x45e
Diagnostic Test Error ($testtype). Status = $status 0x550
System Test ($testtype) on $parttype $partname got an error druing ini-
tializatoin. — $errorstr
0x551
Firmware upgrade failed, please reboot library. 0x650
Firmware upgrade failed, please reboot library. 0x651
Ramdisk space is at $percent usage. 0x652
Slave cabinet $framename $firmwaretype firmware upgrade started 0x653
Slave cabinet $framename $firmwaretype firmware upgrade failed 0x654
System improperly shutdown 0x655
FC Bridge Firmware upgrade, $ip, failed 0x656
Library reboot/shutdown via hardware switch. 0x657
Drive Cluster FPGA upgrade failed upgrading to version $version —
$clustermsg
0x658
Firmware upgrade of $type robot with IP address $ip failed. Library
needs to be rebooted.
0x659
Firmware upgrade of $type robot failed. 0x65a
Firmware of $type with IP address $ip failed. Library needs to be re-
booted.
0x65b
Firmware upgrade of $type robot failed. 0x65c
Rebooted CLM Robot on Cabinet $framename. 0x65d
Rebooted Robotic Controller on Cabinet $framename. 0x65e
The robot for cabinet $framename had a retry of type $robotretry with
a retry count of $retrycount during a $operation operation moving a
tape with barcode $barcode from physical address $srcaddr to physical
address $destaddr.
0x800
The robot for cabinet $framename had a retry of type $robotretry with
a retry count of $retrycount during a $operation operation with a starting
physical address of $startaddr performing an inventory of $count ele-
ments.
0x801
The robot for cabinet $framename had a retry of type $robotretry with
a retry count of $retrycount during a $operation operation positioning
the robot to physical address $destaddr.
0x802
The robot for cabinet $framename had a retry of type $robotretry with
a retry count of $retrycount during a $operation operation.
0x803
Event reporting 154