HP ESL E-series Tape Libraries - Manual (Page 143)

Critical events Event ID
Transport full 0x1c9
Diagnostics command $cmd failed for CLM 0x1ca
Extension invalid command 0x1cf
Error positioning CLM during CLM discovery to cabinet position $position 0x1d0
Inventory error for CLM element during CLM discovery in cabinet $frame-
name 0x1d1
Inventory data error for CLM element during CLM discovery in cabinet
$framename 0x1d2
Home picker error during tape move recovery in cabinet $framename 0x1d3
Picker is unable to determine what tape is in the picker during tape move
recovery in cabinet $framename 0x1d5
Cabinet barcode reader failed to read library identification data 0x1d6
Error positioning cabinet robot to CLM slot 0x1d7
No CLM frame number found for frame $framename 0x1d8
Calibration failed (target not found) 0x1d9
CLM power supplies may have been turned off. Check power supplies
and I2C cable if necessary.
0x1dc
I2C bus failed to respond to read or write command. 0x1dd
Warning safe temperature exceeded 0x1e2
Load port latch failure 0x1e3
$panelname $name sensor needs attention, value $value 0x1e4
Drive $drivenumber, $name sensor needs attention, value $value 0x1e5
Transfer empty - command aborted 0x1e7
$panelname Redundant sensor pair needs attention $name, status $status
value $value, and $redundantname status $redundantstatus, value $re-
dundantvalue.
0x1e8
$panelname Redundant sensor pair needs attention $name, status $status
value $value, and $redundantname status $redundantstatus, value $re-
dundantvalue.
0x1e9
$panelname Redundant sensor pair needs attention $name, status $status
value $value, and $redundantname status $redundantstatus, value $re-
dundantvalue.
0x1ea
Logical unit communication failure 0x1eb
Rotary invalid start condition 0x1ec
Extension invalid start condition 0x1ed
HP StorageWorks ESL E-Series Tape Library 143