HP ESL E-series Tape Libraries - Manual (Page 152)

Warning events Event ID
Transfer full - command can not be executed 0x175
System is stopped 0x176
Logical unit is turned off-line 0x177
$panelname $name sensor may need attention, value $value 0x179
Drive $drivenumber, $name sensor may need attention, value $value 0x17A
Logical unit is not ready 0x17B
Cabinet failed to go online 0x17c
Failed to connect to robot 0x17d
Cleaning cartridge expired in drive $drive 0x17e
Drive cleaning timeout for drive $drive 0x17f
No cleaning cartridge found in the library for drive $drive 0x180
Duplicate barcode detected 0x181
Duplicate barcode $barcode detected in cabinets $origframename and
$dupframename 0x182
Cabinet $framekey $panelname status is $updatetype 0x183
Medium magazine is not accessible 0x184
An element was referenced in a medium magazine that is not present. 0x185
During inventory, $unlabeledtapes unlabeled tapes were detected. 0x186
Configured drive $drive in cabinet $framename is missing or cannot
communicate.
0x187
Cabinet $framename, Card Cage power supplies may be turned off OR
Cabinet Controller does not support monitoring of Card Cage sensors.
0x188
Maximum allowable attempts to change COD settings has been ex-
ceeded. Library must be rebooted before modifications to COD settings
will be accepted.
0x189
Tape in picker for cabinet $framename 0x198
Picker inventory failed for cabinet $framename 0x199
CLM $name sensor may need attention, status $status 0x19b
Diagnostic command $cmd command failed for CLM 0x19c
Tape in CLM for cabinet $framename 0x19d
Panel change detected during robot reconnect for cabinet $framename 0x19e
Drive $drive unload failed because Prevent Media Removal set 0x19f
Event reporting 152