HP XP Continuous Access Software - Manual (Page 95)

NOTE: The controller ID for an XP12000/XP10000 is 4.
•
Path group ID. The path group ID is within the range of 1-FF (hexadecimal). Up to 64
path group IDs can be registered per array.
NOTE: In the current version, the path group IDs always take the default values and
cannot be changed.
8. In the Add DKC pane, select a primary and remote array port to configure a logical path.
9. Click Option.
10. In the DKC Option pane, configure the logical path and array options. For more information,
see Changing options for logical paths and arrays .
11. Click Set to close the DKC Option pane.
12. In the Preset list, check the settings you made.
•
To modify a setting, right-click the setting from the Preset list, and select Modify. A pane
appears where you can modify the setting.
•
To cancel a setting, right-click the setting in the Preset list, and select Cancel.
13. Click Apply to apply the settings.
NOTE: If an error occurs, the right-most column of the Preset list displays the error code. To
view detailed information about the error, right-click the error code, and select Error Detail.
An error message appears providing detailed information about the error.
Figure 43 Add DKC pane
•
DKC S/N: Remote array's five-digit serial number.
•
Controller ID: Remote array's controller ID (that is, array family ID).
Associating primary and remote arrays and configuring logical paths (Add DKC) 95