HP XP Continuous Access Software - Manual (Page 89)

2. On the XP Command View Advanced Edition Software or XP Remote Web Console main
pane, click the XP Continuous Access Journal button ( ). XP Continuous Access Journal starts.
3. Select the DKC Operation tab. The DKC Operation pane appears.
If XP Continuous Access Journal has already been started
• Select the DKC Operation tab. The DKC Operation pane appears.
NOTE: DKC is an acronym for disk controller, which controls an entire array. XP Continuous
Access Journal panes use the word DKC to indicate an array.
DKC Operation pane components
Figure 41 DKC Operation pane, DKC option
•
Switch Display: Changes information displayed in the DKC Operation pane.
DKC: Displays information about remote arrays and logical paths. ◦
◦ Port: Displays information about ports on the local array.
•
Tree: Lists one of the following:
Remote arrays (see Displaying information about remote arrays ) ◦
◦ Channel adapters on the local array and port attributes (see Displaying information about
logical paths )
•
List: Displays one of the following:
Detailed information about remote arrays (see Displaying information about remote arrays ) ◦
◦ Detailed information about logical paths (see Displaying information about logical paths )
◦ Detailed information about ports on the local array (see Displaying information about
ports on local arrays )
•
Preset: Displays changes made in the pane. When you change settings in the pane, the
changes are displayed in the Preset list before the changes are applied to the arrays. If you
are sure that information in the Preset list is correct, click Apply to apply the settings you made.
•
Operation: Displays the operation in progress in the DKC Operation pane.
Displaying the DKC Operation pane 89