HP XP Continuous Access Software - Manual (Page 140)

Displaying detailed information about a pair of data volumes
Use the Pairdisplay pane to view detailed information about a pair of data volumes.
To display detailed information about a pair of data volumes, the primary and secondary array
administrators can perform the following procedure:
1. Display the Pair Operation pane (see Displaying the Pair Operation pane ).
2. In the tree of the Pair Operation pane, right-click a pair.
NOTE: You cannot select more than one pair.
3. Select Pairdisplay.
4. In the Pairdisplay pane ( Figure 61 (page 140) ), view detailed information about the pair.
5. Click Close.
Figure 61 Pairdisplay pane
•
Status: Status of the pair. If the pair is split (or suspended), the column also displays the suspend
type. If the pair is waiting for initial copy, the column also displays Queuing.
•
Alternative Path: Alternate path.
•
Prog./Sync.: If the volume in the local array is a primary data volume, this column displays
an initial copy operation's progress.
If the volume in the local array is a secondary data volume, this column displays the following
information:
◦ If the volume pair is not split, this column displays nothing.
◦ If the volume pair is split and, therefore, is in PSUS or PSUE status, this column usually
displays the synchronization rate (that is, concordance rate) between the secondary data
volume before it was split and the secondary data volume after it was split. For example,
140 Performing XP Continuous Access Journal pair operations