HP XP Continuous Access Software - Manual (Page 86)

Figure 40 Copying access attributes
In Figure 40 (page 86) , if both primary and secondary data volumes have VMA, the primary data
volume's VMA is copied to the secondary data volume. In Figure 40 (page 86) , the secondary
data volume's access attribute is Read/Write when the pair status is SMPL. After the primary data
volume's VMA is copied to the secondary data volume, the secondary data volume's access attribute
becomes Read Only, which is the same as the primary data volume's access attribute. When the
pair status is PAIR, copied information for the access attribute is not effective, so the secondary
data volume's access attribute is still Read/Write. To make the copied information for the access
attribute effective, you must suspend or delete the pair with the Pairsplit-r or Pairsplit-S operation
and make the pair status PSUS or SMPL. However, even if the pair is suspended, S-VOL Disable
does not become effective. To make S-VOL Disable effective, you must delete the pair. For more
information about pair status and operations related to the access attribute, see
Table 25 (page
87) .
86 XP Continuous Access Journal operations requirements and restrictions