HP 12000 Virtual Library System EVA Gateway - Manual (Page 75)

1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Under the System tab, select Chassis in the navigation tree.
3. Under Maintenance Tasks, select System Maintenance.
4. Select Shutdown All Nodes from the task bar.
Shutdown Head Wizard displays.
5. Click Yes to shut down all nodes.
6. If removing the access panel from a node, wait until the VLS has completed its shutdown
operation, then press the UID LED button on the front of the node.
Blue LEDs illuminate on the front and rear panels of the node. Amber system power LEDs
indicate that nodes are in standby mode.
7. Press the Power On/Standby button on any nodes that are not in standby mode.
8. If removing the access panel from a node:
a.
Go to the back of the rack and locate the node by identifying the illuminated rear UID
LED button.
b. Unplug the node AC power cords from the power source. The node is now without power.
NOTE: Under problem conditions, you can use iLO Standard (non-licensed) to power off the
system. You can also use it to determine if the nodes are powered on or off.
Powering Off the System 75