HP 12000 Virtual Library System EVA Gateway - Manual (Page 141)

Table 19 CLI Monitoring Commands (continued)
Usage
1
Command
Returns all the notification alert messages that occurred starting with the specified date.
Where the options are:
-d
- mm/dd/yy on or after this date (required)
getNotificationsDate
-h - Displays command usage information (optional)
Deletes the specified notification alerts from the VLS. Where the options are: deleteNotifications
-id - ID number of notification to delete (required)
-h - Displays command usage information (optional)
Specifies an E-mail server with an SMTP gateway to route notification alerts from the
VLS. Where the options are:
-a
- E-mail server address (required)
addEmailServer
-c - node IP address (required)
-s - Sender email address (optional)
-h - Displays command usage information (optional)
Returns the E-mail server configuration settings for notification alerts. getEmailServer
Deletes the specified E-mail server from the E-mail notification alerts settings. Where the
options are:
-a
- E-mail server address (required)
deleteEmailServer
-c - VLS node IP address (required)
-f - Force - This parameter is ignored and is present only for backward compatibility
(optional)
-h - Displays command usage information (optional)
Adds an E-mail address and desired report formatting to the E-mail notification alert
settings. Where the options are:
-a
- E-mail address (required)
addEmail
-c - VLS IP address (required)
-s - Severity (1-Error, 2-Warning, 4-Info, or 8-Unknown) (optional)
-y - E-mail type (1-Long with attachment, 2-Long, 4-Short, or 8-Reports) (optional)
-h - Displays command usage information (optional)
-f - Notification frequency (0-None, 1-Daily, 2-Weekly, 3-Bi-weekly, or 4-Monthly)
(optional)
Returns the report settings for each E-mail address configured for notification alerts. getEmail
Deletes the specified E-mail address from the E-mail notification alert settings. Where the
options are:
-a
- E-mail address (required)
deleteEmail
-c - VLS node IP address (required)
-f - Force. This parameter is ignored and is present only for backward compatibility
(optional)
-y - Email type (1-long with attachment, 2-long, 4-short, 8-reports, 16-configuration)
(required)
-h - Displays command usage information (optional)
Specifies an SNMP management console to receive SNMP traps from the VLS. Where
the options are:
-a
- SNMP server IP address (required)
addSnmpServer
-c - VLS node IP address (required)
-m - Community (Public, ...) (required)
-v - Trap version (required)
-s - Severity (1-Error, 2-Warning, 4-Info, or 8-Unknown) (required)
VLS Commands 141