HP 12000 Virtual Library System EVA Gateway - Manual (Page 134)

Table 16 CLI Network Settings Configuration Commands (continued)
Description Command
Displays the day, date, time, time zone, and year (such as Mon March 14 11:30:46
EST 2005). getDateTime
Sets the date and time. Where the options are:
-d <”s”>
- Date and time in yyyy-mm-dd hh:mm format (hh is 24 hour from 0) (required).
Example: setDateTime -d “2009-06-09 09:45:00”
setDateTime
-h - Displays command usage information (optional)
Saves the system values changed using setConfigValue. commitConfig
NOTE: To reset a value to its default setting, set the option tag to " " (quoted space). For example:
fullhost=" "
The exception to this is the dhcp tag. DHCP is disabled by entering:
-dhcp=false
Any network configuration changes made using setConfigValue do not take effect until
“committed”, using the commitConfig command.
Configuration Commands
Use the CLI commands in CLI configuration commands to:
•
Edit the Fibre Channel host port settings
•
Enable oversubscription and view oversubscription settings
•
View LUN mapping
•
Create, view, and destroy virtual libraries, tape drives, or cartridges
•
Add, view, or remove barcode templates
Table 17 CLI Configuration Commands
Usage
1
Command
Discovers any new arrays added to the VLS. discoverArray
Changes the default FC host port connection settings. Where the options are:
-a
- ID number of node to modify (0, ...) (optional)
updateFC
-i - FC index (0, 1, ...) (required)
-l - If attached in arbitrated loop mode, specifies a hard ALPA value between 0
and 125. A value of -1 specifies a dynamically assigned ALPA. If not attached to an
arbitrated loop, this parameter is ignored (required)
-r - Port number of the FC port to modify (required)
-s - Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten GB)
(required)
-t - Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public Loop)
(required)
-h - Displays command usage information (optional)
Enables or disables oversubscription and specifies the percent storage remaining for
notification. Where the options are:
-e
- Enable/disable oversubscription (0-Disabled or 1-Enabled) (required)
setOverSubscription
-p - Percentage of capacity remaining for alert notification (required)
-h - Displays command usage information (optional)
134 CLI Command Set