Installing a hot-plug scsi hard disk drive, Installing a hot-plug scsi hard disk drive -29 – HP ProLiant DL760 G2 Server User Manual
Page 144
Installing Hardware Options, Hot-Pluggable
Installing a Hot-Plug SCSI Hard Disk Drive
CAUTION: Before adding or removing any hot-plug SCSI drives, consult your
operating system instructions. Failure to do so could result in loss of data or damage
to equipment.
To install a hot-plug SCSI hard drive:
1. Remove the blanking panel in an unused drive bay by pushing the side of the
retaining clip inward (1), and then pull the blanking panel outward (2).
Figure 5-12: Removing a hard-drive blanking panel
2. Push the release button on the left of the new drive, and rotate the hot-plug drive
ejector lever outward to unlock the drive.
HP ProLiant DL760 Generation 2 Server User Guide
5-29
HP CONFIDENTIAL
Writer: Bryce Miller File Name: f-ch5 Installing Options-Hot Pluggable.doc
Codename: Comet Part Number: 201264-001 Last Saved On: 6/17/03 9:47 AM