HP 9100c Digital Sender series - Manual (Page 48)

46 Chapter 2 - Working at the digital sender EN
Sending to another program
If function keys are labeled for use with network storage locations,
you can send documents to those destinations and use the
documents with specified programs.
To send to another program
Note At any time before pressing to send the document, you can press
or B ACK to return to the main screen without saving any settings.
1 At the digital sender, log in (if prompted).
2 Press the function key for the destination you want. (It is named
whatever the administrator chose.) If the destination is not on the
bottom row of the display, use the and keys to move it to the
bottom row.
3 Use the and keys to select a secondary destination from the
list.
4 The current Quality setting is shown in the upper right corner of
the display. For options and instructions on changing this setting
or the (paper) Size setting, see “Changing settings” on page 35.
5 Press to begin sending the document.
• If you sent a single-sided document using the ADF, the
process is finished.
• If you sent a double-sided document using the ADF, wait for
the first side to finish. Then, reload the document with the
second side facing up, last page on top, and press
again.
• If you used the glass, remove the page when it is finished.
Then, place the next page face down on the glass and press
. After the last page, press S END .