HP Insight Management-Software - Manual (Page 83)

4. (Optional) To change the network access group:
1. Choose the Network Access Group selection box.
2. Choose another network access group. A warning message similar to the following can
appear if Ethernet networks, multiple, or iSCSI connections are not associated with this
network access group: VCEM will unassign all Ethernet/iSCSI connections
in this server profile that are assigned to a Network with no
association to the selected Network Access Group [nag1]. Do you
want proceed with the Network Access Group change? Click "OK" to
proceed with the Network Access Group change or click "Cancel"
to keep the current connections.
5. Enter changes to the Ethernet network connections (physical ports) as needed, and then click
Add Network Connection.
6. Enter changes to Fibre Channel SAN connections, and Fibre Channel boot parameters as
necessary. Depending on the physical changes to the Fibre Channel Virtual Connect modules,
the Add FC Connection button or the Remove FC Connection button appears.
7. (Optional) To erase the current EFI partition information in the integrity blades assigned server
profiles, select Cleanup the EFI partition data.
8. (Optional) Edit the Flex-10 iSCSI Connections table and the iSCSI Boot Setting column as
necessary.
9. (Optional) Edit the FCoE Connections column and the FCoE Boot parameters table as necessary.
10. (Optional) To inform the bay assignment, select VC Domain, and then select an available
target server bay. If a server profile is not assigned to a server bay or fails to assign to a server
bay, then that server profile is saved as unassigned in the VC Domain Group. The Assign to
bay button is available only if the selected server profile being edited is unassigned.
11. Verify the server bay assignment.
12. Click OK. The Virtual Connect Enterprise Manager is executing the request
message appears.
13. Click OK to go to the Jobs page and monitor job progress.
Extending mapped networks
The latest VC firmware has a resource that increases the maximum number of multiple networks to
1000. To support this maximum number of multiple networks, Expanded VLAN capacity is provided.
As the number of networks available to a VC Domain group server profile increases significantly,
a filter for networks is available. You can find networks by labels and colors too.
There are two options available when selecting an Ethernet network:
•
Select a Network
•
Multiple Networks
Because multiple networks are not supported for iSCSI connections, only Select a Network is
available.
When a network is already selected, click Change Network to edit it.
Selecting a single network
When selecting a single network, you can filter with the following options:
•
Name
•
Shared Uplink Set
•
VLAN Id
•
Label
•
Color
Extending mapped networks 83