HP Insight Management-Software - Manual (Page 82)

2. (Optional) To select the desired port speed for the connection, select Custom. The Custom Port
Speed windows appears. Enter the desired port speed.
Figure 41 Custom Port Speed window
Deleting a server profile
VCEM detects the presence of logical server managers or upper level managers. When performing
this task, a prompt dialog message appears and explains the impact of performing that task from
outside the logical server manager or upper level manager. The following message appears:
IMPORTANT: VCEM has detected you may be using other products, such as
such as HP Matrix Operating Environment. Deleting this VC Domain Group
will make it and any Server Profiles in this VC Domain Group unmanageable
by this upper level manager. Type YES to proceed with this operation.
To proceed, you must type YES, and then click OK. VCEM does not proceed if you cut and paste
YES into the field.
1.
From the Server Profiles page, select the server profiles to be deleted.
2. Click Delete. You are prompted to confirm the deletion.
3. Click OK to go to the Jobs page and monitor job progress.
Editing a server profile
NOTE: In a VC Domain Group with VC firmware 2.1x, the 8Gb FC module appears only if
VCEM detects it. If VCEM detects the 4Gb FC module, then the maximum port speed will be 4Gb.
VCEM detects the presence of logical server managers or upper level managers. When performing
this task, a prompt dialog message appears and explains the impact of performing that task from
outside the logical server manager or upper level manager. The following message appears:
IMPORTANT: VCEM has detected you may be using other products, such as
HP Matrix Operating Environment. Editing this Server Profile can make
it inconsistent with the upper level manager. It is recommended to use
the upper level manager to edit this Server Profile. Type YES to proceed
with this operation.
To proceed, you must type YES, and then click OK. VCEM does not proceed if you cut and paste
YES into the field.
When editing server profiles, VC Domain Group memberships and server bay assignments are
read only. To edit a server profile:
1.
From the Server Profiles page, select the server profile to be edited.
2. Click Edit. The Edit Server Profile information appears below the server profile table.
3. Enter changes to the Server Profile name as needed.
82 Managing server profiles