HP Insight Management-Software - Manual (Page 102)

The following table lists and describes the MAC address status at Individual address page.
Description Item
Address available to use in VCEM. Free
Address currently used by a server profile in VCEM. In use
Addresses used by server profiles in a VC Domain that
have been released back to Virtual Connect Manager and
no longer managed by VCEM. External Address
Addresses that reside in a VCEM Exclusion range list.
VCEM will not allocate any address that is marked as
excluded. Excluded Addresses
Creating MAC exclusion ranges
VCEM requires that you define exclusion ranges for both MAC and WWN addresses if:
•
VCEM and VC Domains outside of VCEM management are sharing the same user-defined
MAC and WWN ranges.
•
VCEM is running in a federated CMS environment where multiple instances of the VCEM
application are operating on the same network.
NOTE: In the case of federated CMS environments, you can select from a pre-defined VCEM
MAC subrange during a new HP Insight Management DVD installation.
Exclusion ranges are used to set aside addresses that might be in use for other purposes within
your data center. Excluded address ranges are not assigned for use by VCEM.
1.
From the VCEM home page, under the Administration heading, click the MAC addresses
hyperlink.
2. From the Select ranges to configure list, select MAC.
3. Select a MAC address range from the MAC ranges list. You can also look at Range Usage
to determine the percentage of free exclusion ranges. The exclusion range must be contained
within the address range to which the exclusion range belongs.
4. Select the Exclusion ranges tab and choose from the list of ranges.
5. To create the exclusion range, click New.
IMPORTANT: External addresses that are included in a MAC exclusion range remain external
addresses. The status of an external address does not change if it is included in a MAC
exclusion range.
6. Manually enter the address range to exclude it.
Deleting MAC exclusion ranges
1. From the VCEM home page, under the Administration heading, click the MAC addresses
hyperlink.
2. From the Select ranges to configure list, select MAC.
3. Select a MAC address range. The exclusion range must be contained within the address range
to which the exclusion range belongs.
IMPORTANT: After upgrading to VCEM 1.4x or later, HP recommends that you delete any
exclusion ranges for HP predefined MAC and WWN addresses.
4. Select a MAC exclusion range.
5. Click Delete. You are prompted to confirm your choice.
102 Managing MAC and WWN addresses