HP Storage Mirroring Software - Manual (Page 98)

7 - 17
6. To modify the location of renamed orphan files, use the set command with the MoveOrphansDir option. This option
accepts any valid volume and directory. By default, the directory is the same drive where Storage Mirroring is running in
a directory called
\RemoveOrphans .
7. To determine if orphaned files are being logged on the target, use the get command with the LogAllOrphans option.
8. To modify whether or not the orphaned files are logged to the Storage Mirroring log on the target, use the set
command with the LogAllOrphans option. This option is set to 0 to not log the files or 1 to log the files.
9. Orphan files will be removed or renamed, depending on your settings, when a mirror, verify, or restore is performed. If
you want to remove orphan files manually, use the
orphans start command.
10. If you want to stop removing orphan files after it has been started, use the orphans stop command.
NOTE: If you are moving files, make sure the directory you specify to move the files to is not included in the
destination of the replication set data so that the orphan files are only moved once.
Command ORPHANS START
Description Manual operation to remove any orphan files on the target
Syntax ORPHANS START con_id
Options con_id —Connection ID assigned to the source/target connection
Examples orphans start 1
Command ORPHANS STOP
Description Stops the process to remove orphan files on the target
Syntax ORPHANS STOP con_id
Options con_id —Connection ID assigned to the source/target connection
Examples orphans stop 1