HP Storage Mirroring Software - Manual (Page 280)

A - 17
Monitor Script Remove
Monitor Start
Command MONITOR SCRIPT REMOVE
Description Specifies the scripts that should not be run during the failover and failback processes
Syntax MONITOR SCRIPT REMOVE < type > [ monitor ]
Options ! type —Any of the following script types:
! PREFAILOVER —Specifies that the file is a pre-failover script to be run on the target before
failover occurs
! POSTFAILOVER —Specifies that the file is a post-failover script to be run on the target after
failover occurs
! PREFAILBACK —Specifies that the file is a pre-failback script to be run on the target before
failback occurs
! POSTFAILBACK —Specifies that the file is a post-failback script to be run on the target after
failback occurs
! SRCPOSTFAILBACK —Specifies that the file is a pre-failback script to be run on the source
after failback occurs
! monitor —Name of the source machine designated as the monitor
Examples ! monitor script remove prefailback
! monitor script remove postfailover
Notes If you do not specify a monitor, the current source designated as the monitor will be used. If you
have not identified a monitor, you will receive an error message stating that a monitor has not been
selected.
Command MONITOR START
Description The configured failover target starts monitoring the source machine that was designated as the
monitor.
Syntax MONITOR START < monitor > [ON < target_machine >]
Options ! monitor —Name of the source machine designated as the monitor
! target_machine —Name of the target machine that will be monitoring the source machine
Examples monitor start indy on jersey