beautypg.com

Verify communication setting for new bond – HP LeftHand P4000 Virtual SAN Appliance Software User Manual

Page 67

background image

NOTE:

Because it can take a few minutes for the storage system to re-initialize, the search

may fail the first time. If the search fails, wait a minute or two and choose Try Again on the
Network Search Failed message.

12.

Verify the new bond interface.

Figure 31 Viewing a new Active-Passive bond

1. Bonded logical network interface

2. Physical interfaces shown as slaves

The bond interface shows as “bond0” and has a static IP address. The two physical NICs
now show as slaves in the Mode column.

13.

(Optional, for Active-Passive bonds only) To change which interface is the preferred interface
in an Active-Passive bond, on the TCP Status tab select one of the NICs in the bond, and click
Set Preferred.

Verify communication setting for new bond

1.

Select a storage system, and open the tree below it.

2.

Select the TCP/IP Network category, and click the Communication tab.

Configuring network interface bonds

67

This manual is related to the following products: