Transmille 1000-Series - Manual (Page 84)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 84
Capacitance Commands
Function Range Command
Capacitance
10nF R35
100nF R38
1uF R39
Standby Mode
Standby ON S1
Standby OFF S0
The capacitance section consists of a set of range commands which are used in
conjunction with the standby command. To enable a capacitance to be set, the
following command sequence should be used:
/
The use of the output (O) command is not necessary as the capacitance ranges are
fixed ranges at decade points.
For example, to set the 10nF output with the output switched on, the command is :
R35/S0
R35 = 10nF Range (as detailed in the table above)
S0 = Standby OFF (i.e. output switched ON)
= Carriage Return (ASCII character 13)