Transmille 1000-Series - Manual (Page 8)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 8
Preparing The Calibrator For Use.
Initial inspection.
After shipment the calibrator should be inspected for any signs of external damage.
Should external damage be found contact the carrier immediately. Do not connect a
damaged instrument to the line power as this may result in internal damage. Please
retain the original packaging; this should be used when returning the calibrator for
service and recalibration.
Before connecting to Line power, ensure that the input voltage of the calibrator
matches your supply voltage. For further information on verifying the input voltage,
please refer to Page 11
Lifting and Carrying the Calibrator
The calibrator weighs 9.5kg so can be carried by one person. (note: observe all
normal practices for health and safety when carrying). The calibrator should always
be placed down on a firm flat surface on its base feet. Avoid knocking or banging the
calibrator and always place down smoothly.
The 1000A, in the ruggedized case should always be transported with the lid closed
to protect the front panel of the instrument from accidental damage.
Warning: DO NOT DROP THE CALIBRATOR
This may cause internal damage which will not be covered under
warranty