Transmille 1000-Series - Manual (Page 34)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 34
Setting An Output
Using the Keyboard
Setting the output of the calibrator is similar to entering values on a calculator.
Simply press the keys to enter the value required, select a multiplier (i.e. m for milli),
and then select the units, i.e. volts.
The new value will appear under the current set value on the calibrator display.
Once you are happy with the new value, press
For example, to set 10 volts DC
To set 5V AC at 50Hz
To return to DC
The calibrator will retain the value of the last output when switching between DC and
AC modes, i.e. switching from 5V at 50Hz, pressing the DC key will switch the
calibrator output to 5V DC. The calibrator will switch into standby mode when
switching between DC and AC outputs.
Worked examples are provided for the following outputs:
 DC Voltage
 DC Current
 AC Voltage
 AC Current
 Resistance (Simulated)
 Resistance (Passive)
 Capacitance
 Frequency
 Thermocouple Output
 PRT / RTD Output
 Using a Current Coil
 Insulation Resistance Measurement
 Insulation Test Voltage Measurement
 Continuity Current Measurement
DC 1 0 V
AC 5 V 5 0 HZ
DC