Transmille 1000-Series - Manual (Page 52)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 52
Setting Frequency Output.
Note: The calibrator uses a precision crystal oscillator for frequency output.
Frequencies from 1Hz to 100kHz in 1Hz steps are available.
Complete the following example to set an output using the frequency output.
1) Ensure the calibrator’s output has been set to Standby. This can be verified
by ensuring that standby is indicated on the display, and the output standby
status LED is lit.
2) Connect the UUT to the calibrator as described for frequency measurements
(see connection diagram on Page 31)
3) Select the correct range on the UUT
4) Press the numeric and decimal point keys to enter the required value, e.g.
1.234
5) Press the multiplier key (if required) e.g.
6) Press
7) The display will now indicate the value that has been entered below the
currently set output
8) Press . The new value will replace the existing output in the middle
of the display