Transmille 1000-Series - Manual (Page 72)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 72
Returning to Local Control
When the calibrator has been controlled from the interface, the front panel controls
are disabled. To regain front panel control use the LOCAL soft key
Programming Commands Overview
The 1000 Series calibrators are controlled by a set of simple high level commands
which can be used either individually or as part of a command sequence.
The commands can be joined together using the / (forward slash) character.
The required terminator for the commands to be detected by the calibrator is a
carriage return (ASCII character 13) and should be the last character sent on a
command line.
For Example:
Command1/Command2
Where each command is represented as Commandx
(x being the command number)
and the carriage return (ASCII character 13) is represented by