Transmille 1000-Series - Manual (Page 44)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 44
9) Press . The new value will replace the existing output in the middle
of the display.
10) Press the numeric and decimal point keys to enter in the desired frequency,
e.g. 80
11) Press the multiplier key (if required) e.g.
12) Press
13) The display will show the new entry below the previous set value.
14) Press The new value will replace the existing frequency on the right
of the display.
15) Press to activate the calibrator output. The LED next to the key will
light up, as well as the terminal indicator; indicating that the output is active.
The calibrator will now source 5.6789A at 60Hz at the high current terminals. Once
on a range, any new output within that range can be set without the calibrator
returning to standby.
Depending upon the output selected, the current will be sourced between different
terminals. For currents of 1A and below, the current will be sourced between the
Common Low Current (Blue Terminal) and Common (Black Terminal). Currents
above 1A will be sourced between the High Current (Yellow Terminal) and Common
(Black Terminal).