Transmille 1000-Series - Manual (Page 12)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 12
Warning: Ensure Line Power has been disconnected from
the instrument before performing this procedure
Using a Flat Head screwdriver, insert the end of the screw driver into the recess on
the fuse holder. The screwdriver must be parallel to the front panel of the calibrator
Once the screwdriver is in the recess of the fuse holder, gently hinge the fuse holder
up (away from the front panel). Be careful not to damage the fuse holder by applying
too much force. The fuse holder will lift out, revealing the fuse. Check the fuse using
a continuity tester to ensure that the problem is the fuse. If the fuse is damaged,
replace the fuse with an anti-surge fuse of the recommended rating for the supply
voltage. Re-insert the fuse holder in the same orientation as it was removed.