Transmille 1000-Series - Manual (Page 43)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 43
Setting an AC Current Output
Complete the following procedure to set an AC current output. The and keys
can be used to edit the entry in the event of an incorrect key press.
Warning: ENSURE CONNECTIONS TO UUT ARE CORRECT
To avoid damaging UUT protection fuses, ensure the correct terminals
on the UUT are used before sourcing currents
1) Ensure the calibrator’s output has been set to Standby. This can be verified
by ensuring that standby is indicated on the display, and the output standby
status LED is lit.
2) Connect the UUT to the calibrator as described for AC current measurements
(see connection diagram on Page 29)
3) Select the correct range on the UUT
4) Press
5) Press the numeric and decimal point keys to enter the required value, e.g.
5.6789
6) Press the multiplier key (if required) e.g.
7) Press
8) The display will now indicate the value that has been entered below the
currently set output.