NORD Drivesystems BU0290 - Manual (Page 67)

8 Additional information
BU 0290 GB-4312 Subject to technical amendments 67
Flanged coupling
Flanged plug
connector
8.2.2 Connection with M12 round plug connectors
In order to implement detachable connections, the cable connections for the system bus
and for sensors and actuators, as well as for the 24V- supply voltage can be designed with
plug-in connectors.
Here, freely adjustable M12 flanged connectors with metric M16 x 1.5 threads should be
used for installation in the relevant housing (SK TI4-
…(-BUS)).
This allows the use of angled or straight M12 round plug connectors for the cable
connection.
If required, Getriebebau Nord GmbH can equip the device to be delivered accordingly, or
can enclose the required plug with the delivery.
EMC compatible assembly is carried out in the same manner as for the assembly of the
cable glands (Section 8.2.1 "Fixed connection (cable gland)").
8.2.3 Round plug connectors
Getriebebau Nord GmbH offers a selection of suitable plug connectors and couplings, which can be installed in
the connection units of the frequency inverters or the field bus module, or enclosed with the delivery as
required. The corresponding plug connectors, couplings and Y connectors are also commercially available.
However, a limited selection can also be obtained from Getriebebau NORD GmbH.
Coding
Round plug connectors are coded. Coding is by means of a pin or a groove on the contact base. The most
common codings are the so-called A and B coding. This serves to protect against incorrect coupling of the
various field bus systems.
Designation A coding B coding D coding
Example
Connector (socket)
Format M12 M12 M12
Coupling version with coding groove with coding pin with coding pin and
groove
Plug connector version with coding pin with coding groove with coding groove and
pin
Field of use
System bus
CANopen
DeviceNet
24V supply
Sensors and actuators PROFIBUS DP EtherCAT
PROFINET
EtherNet/IP
POWERLINK