Overview of the canopen modules – NORD Drivesystems BU0260 User Manual
Page 16
Supplementary Manual CANopen for NORDAC SK 20E
16
Subject to technical amendments
BU 0260 GB
2.1.1
Overview of the CANopen modules
Bus Module
Description
Data
CANopen Module
SK CU4-CAO
Part No. 275271001 (IP20)
Similar to illustration
This option enables control of the NORDAC SK
200E via CANopen.
This option is integrated into the connection unit of
the frequency inverter.
Supported profiles:
CiA DS-301 and CiA DSP-402
baud rate:
up to 1 MBaud
Connection:
16-terminal screw terminal bar
2x digital inputs:
Low: 0-5V, High: 11-30V
System bus
CANopen module
*)
SK TU4-CAO(-C)
Part No. 275281101 (IP55)
Part No. 275281151 (IP66)
This option enables control of the NORDAC SK
200E via CANopen.
This option is installed externally to the frequency
inverter.
According to the installation location, at least one
"BUS connection unit"* is required.
Supported profiles:
CiA DS-301 and CiA DSP-402
baud rate:
up to 1 MBaud
Connection:
36 pin spring terminal bar of the
“BUS connection unit”*
4x digital inputs:
Low: 0-5V, High: 11-30V
2x Digital outputs:
0/24V
System bus
CANopen module with
M12
*)
SK TU4-CAO-M12(-C)
Part No. 275281201 (IP55)
Part No. 275281251 (IP66)
This option enables control of the NORDAC SK
200E via CANopen.
This option is installed externally to the frequency
inverter.
According to the installation location, at least one
"BUS connection unit"* is required.
As for SK TU4-CAO, but with
additional:
6x M12 socket for the connection
of up to 4 sensors and 2
actuators via 5 pin M12 round
plug connectors (A coded)
Connection unit for TU4
SK TI4-TU-BUS
Part No. 275280000 (IP55)
Part No. 275280500 (IP66)
The connection unit is always required in order to
use an external technology unit (SK TU4-...). This
implements the connection of the technology unit to
the SK 200E or the wall-mounting kit.
Connection:
36 pin spring terminal bar
36x 2,5mm
2
AWG 26-14
spring terminals
TU4 Wall-mounting kit
SK TIE4-WMK-TU
Part. No. 275274002
With the wall mounting kit, a technology unit can be
used/installed separately from the SK 200E.
*)
in order to use the TU4 modules, a suitable SK TI4-TU-BUS connection unit must always be available!