West Control Solutions DataVU 7 - Manual (Page 73)

73
6 Alarm and Event Lists
The alarm and event lists can be called up in two ways:
- A call from one of the visualization modes, e.g. curve presentation
(diagram)
(Chapter 4.2 "Overview of Header Lines")
and
- A call from the memory presentation
(Chapter 5 "Memory Presentation (History)").
Alarm lists Alarm lists contain only the alarms and errors that are currently present.
Event lists Events list contain all the events that have occurred, including all alarms and
errors.
A
The alarm list will not be updated as long as the window is open.
Remedy: Close once, and open again. This will update the alarms.
H
A maximum of 150 entries can be fitted into the two lists. The lists
will be deleted if a reconfiguration takes place.
H
The following description assumes that three batches are being
used. The number of batches may vary, because it can be
configured by the user.