West Control Solutions DataVU 7 - Manual (Page 140)

19 Configuration Report
140
Synchronization
time Synchronization time is used for the daily, weekly and periodic report, for the
report end and restart.
The parameter Synchronization time is explained below, using a period report
as an example.
Stop and restart will occur at the next instant of time which fits into the time
grid, dependent on the Synchronization time and Period.
Example:
Period = 2 hours
Synchronization time = 11:30:00
Power ON = 09:11:00
1. Period 1 from 09:11 to 09:30 = 19 minutes
2. Period from 09:30 to 11:30 = 2 hours
3. Period 3 from 11:30 to 13:30 = 2 hours
etc.
Out of range „Out of range“ determines what happens when an internal or external analog
input, or an allocated math channel, is outside the valid measurement range
(scaling).
H
The principle is identical for all reports that are dependent on the
Synchronization time (daily, weekly and periodic report).
As a rule, in the case of the daily report, the first report will not be
run for 24 hours, and, in case of the weekly report, not for 7 days.
Stop The channel reports are stopped. When the
measurements are within the range limits again, they will
continue to be run.
Delete The reports are set to invalid (“-----”) and will be
restarted only after the configured report end has
elapsed.